fumanchu182
3000 Posts Club
Vendor
Premium Account
U.S. Navy Veteran
Donating Member
9 Second Best E/T
HFCOTM
Thread Starter
#1,041
- Member ID
- #2366
- Messages
- 3,534
- Reactions
- 8,609
- Likes
- 302
- City
- Pasadena
- State
- MD
- Country
- United States
- Vehicle
- 2015 Challenger SRT Hellcat
Thread Starter
#1,041
Keep us updated.
![FF600636-69D7-4BBD-96A6-CB06CE8AD69E.jpeg](/data/attachments/93/93244-b2a6432903055d3b71d29063ed2ba794.jpg)
![8F16C6C7-4E5E-40B8-BFB4-9D618D17AAD8.jpeg](/data/attachments/93/93245-4a4f6b533012c272707c9a52aff471a4.jpg)
Step 2 install support brackets for chiller. Tools required: 8mm, 10mm and 13mm sockets or wrenches. Swearing optional. Start with the smaller bracket, leave some what loose til final tightening sequence.
![E621E44A-9062-46DC-A2DF-2958DD268CDB.jpeg](/data/attachments/93/93246-b2291a9e0d0ff377ae1fb99295e2a70e.jpg)
![B1F63997-8963-47D2-9263-B4BF277AE60A.jpeg](/data/attachments/93/93247-338a1a129f3a95ea632f947e0ea0ab2a.jpg)
Attach cross bracket, take note of logo placement and holes the bolts are placed in.
![54937D1C-FB86-4E1C-8A7E-6164EF512C10.jpeg](/data/attachments/93/93249-9ce043f2dcfbdd3061b48bea3de30ecb.jpg)
My tightening sequence was rear bolt, front bolt, connector bolt. Attach chiller brick from below and start the middle nut.
![7A015E7C-3CAE-45FE-AE30-8BC408915D93.jpeg](/data/attachments/93/93248-3e7cf8642f4c4a293ddadefd12596d2a.jpg)
the rear nut was the biggest pain in the ass to get started and tight. This is where swearing is recommended. I created a new one: dildo-headed-cock-fucker.
![6649FFFC-1459-4D28-8062-B2445D2794CA.jpeg](/data/attachments/93/93250-1b7ef7b61a98038acafcc437684755a5.jpg)
I have attached LTR removal instructions from the FSM.
Attachments
-
174.4 KB Views: 6
-
101.5 KB Views: 7
-
3
-
3
-
2
- Show All